Hyundai IONIQ Forum banner

Found a trick to get the wireless AA / Carplay adapter to auto power on / off.

2 reading
25K views 33 replies 19 participants last post by  niromad  
#1 · (Edited)
Found this trick from a sportage owner. If you have a wireless AA or Carplay adapter that doesn't turn it self off like mine you either need to unplug it or put a switch on it so it won't keep connecting and disconnecting for hours in your house. But if you buy a USB Y cable and a USB power blocker you can make it automatically power off and on with the car. Put the Power Blocker on the Ioniq's USB port, it will pass though data but not power. Then plug the other side into the lighter socket, it only powers on when the car is on. So the adapter only now gets power from the switched lighter socket and not the USB port, so it turns on/off with the car. I tried it tonight and it worked great, powers on with the car and connects to wireless AA then turns back off with the car.




The right angle adapters are optional, I did it to keep the cable out of the way. Or you could also pull apart a USB Y cable and cut the power wire
, leave the data wires.

 
#13 ·
OK - so reading through again it seems the theory is the USB is powered during the 12V recharge but the lighter socket is not? Is that confirmed that the lighter socket is not powered during 12V recharge?

We have been using the Carlink for a 2 - 3 weeks and haven't noticed either of our phones connecting to the adapter once it powers down. Maybe we have been lucky?
 
#14 ·
I turned off the auto unlock, auto mirror extension, and auto tailgate lift on my car since every time that my key was detected, the port turned on. I have verified that now everything stays off once the power times out and only comes on after I unlock my car. I would bet all those sensors always on probably run down the 12v battery.
 
#32 ·
Thanks to all the posters for the advice as it helped me get this setup on an Ioniq 5 with the Carlinkit 5.0. I had a similar problem that when using only the usb port for power and data, at times my phone would connect to CarPlay while inside the house.

Purchased the Y cable as OP suggested and a flush adapter for the 12V lighter. I have the power blocker on order, but shipping is about a week. So I cut a small piece of electrical tape and covered the power pin on the USB 3.0 male connector on the Y cable. Worked perfectly!
 
#33 ·
Gear Used:
Y Splitter:

Cig Lighter Adapter:

Carlinkit 5.0:

PortaPow Power Blocker (in transit, haven't tested):