Is there a way to keep AUTO regen to stay defaulted when starting the car?
Thanks

Are you signed in as a user, you get 2 users and 1 guest. I believe individual settings are all stored in their. I did also notice that if you switch to Snow Mode, it unsets various things you saved like Auto Regen,

 

Yeah I'm my own user. Is it because you have a EURO ioniq5 and I have a US ioniq5? I was reading that some owners with the EURO i5 stays on auto when they start their car.

 

Mine starts in Auto, no issue. Euro spec, if it matters.

 

So no matter what setting you had previously, it will always start back up with what you had left off before?

 

Well no, i-pedal never stick after restart (or even after reversing). Auto does. I don't remember now about the 0 to 3 modes, don't use these at all.
Frankly I stopped using i-pedal because of this annoyance, and after using Auto for a while I fell in love with its convenience.
BTW despite common beliefs i-pedal does not save energy or increases range, normal use of the break pedal regens just as much electricity, regardless in which regen mode you are.

 

I used to love using i-pedal, then tried auto mode for shiggles and found it slightly better.
I then realised that when you are in auto (all levels) the brake light kicks in a lot more than is necessary. As I would normally get annoyed if I'm behind a driver who constantly taps their brakes, it put me off using auto mode.
I'm now happily back to using i-pedal full time.

 

No way to do this. I’ve tried all sorts of combinations and it doesn’t stay. Actually a thread already on this subject.

 

It works for me. Maybe it depends on software versions?

 

Is there a way to keep AUTO regen to stay defaulted when starting the car?
Whenever I turn off the car and then start it up the following day it goes back to level 1 regen mode. I would have to switch it back to AUTO REGEN by holding the right steering paddle.

Thanks

Turn car On/Setup/EV/Smart Regeneration System/Strong to Gentle Deceleration selections but no i-Pedal

 

Works for me if I hold the right paddle up for a couple of seconds until "Auto" appears. It stays that way the next time I start up as well.