The right brake light bulb (non LED) went out and the manual says to remove the two screws that holds the rear combination lamp assembly so that the whole assembly can be removed to access and replace the bulb. However, after I removed the two screws, the said lamp assembly is loose but cannot be removed the way its depicted by the photos in the manual (page 7-67,68). Seems like there is something else holding on to it. Any suggestions? Hate to spend $$ on labor just to replace a bulb.
-
US ICCU Recall (aka 12V battery failure issue) and Tesla Supercharger access and adapters. Please do not create duplicate threads on these topics. Links: ICCU Thread | Supercharger Thread | Adapter Thread
Gomra
Here's a video I found of someone removing the tail light on the EV. I'm sure it's the same on all of them.
I was about to post that link
Your video was the first applicable result when I searched.-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
